ADSORPTION OF PALM OIL WITH SYNTHETIC ADSORBENT (COAL)
Sold By: Joe Project Store | Item Type: Project Material | Report this? | Attributes: 65 pages | 1-5 chapters | Amount: ₦5,000 | Marked useful: 5,997 times
Delivery: Within 24 hoursABSTRACT
This project was Carrie lent using sub-bituminous coal and crude palm oil. The degree of bleaching of the palm oil was monitored with a spectorphoto meter. The coal was collected in a lump from the mine. It air-chiecl to removed the moisture content and thereafter, size reduced to a small particle size foe effective activation. The activation process was carried out in a fume cup board and phosphoric acid was used as an activated agent. In the treatment of palm oil, sodium hydro rude was used for the neutralization and rude acid for the deodorization of palm oil. Some experiment were also conducted to test for the iodine value, specification value, peroxide value, acidity value, melting point, free fatly acid value, and viscosity of palm oil. After the preliminary treatment, the colour of palm oil was tested with a spectrophomenter to determined the initial colour of the palm oil. 100ml of these palm oil was measured into a beaker,10g of coal activated carbon with the particle size of 0.185mm was added to the beaker and heated at a temperature of 1000c for 40minute. The oil was allow to cooled, thereafter it was filtered with a filter paper to collect the filtrate. The colour of the bleached oli tested to determined the degree of beaching. The same experiment was repeated with the same weight of coal activated carbon at two difference temperature of 1500c and 2000c the result obtained was recorded and the colour reduction was, at 1000c, colour reduction was 57%, at 1500c, the % colour reduction was 75%,at 2000c, the % colour reduction was 81%. The same experiment was also conduction with 10g each of 0.45 particle size of activated carbon for three difference temperature of 1000c, 1500c and 2000c at a constant time of 40 minute each. The result obtained was recorded and colour reduction for each experiment was, at 1000c, % colour reduction was 52%, at 1500,% colour reduction was 69%, at 2000c,% colour reduction 70%. It was observed that the smallest particle size of coal activated carbon has a higher percentage of colour reduction. Also it was noticed that, as the temperature of heating increases, colour reduction also increase.TABLE OF CONTENT
CHAPTER ONE1.1 INTRODUCTION
1.2 Scope/Objective of The Project
CHAPTER TWO2.1 Theory of Adsorption
2.12 Type of Adsorption
2.13 Equilibrium Relations of Adsorption
(A) Langmuir Isotherm Theory
(B) Brunur-Emmett-Teller Theory
(C) Freunlich Isotherm
2.2 Plam Oil
2.22 Composition of Palm Oil
2.23 Properties of Palm Oil
2.24 Uses of Palm Oil
2.31 History of Coal in Nigeria
2.32 Coal Formation
2.33 Classification of Coal
2.34 Properties of Coal
CHAPTER THREE3.1 Activation of Coal
3.12 Experimental Method of Coal Activation
3.13 Test For Porosity & Density
3.20 Preliminary Treatment of Palm Oil
2.23 Characterization of Palm Oil
3.3 Method of Adsorption
3.4 Experiment Result
CHAPTER FOUR4.0 Analysis of Result
4.1 Analysis of Coal Activated Carbon
4.2 Analysis of Palm Oil
4.3 Analysis of Colour Reduction
.CHAPTER FIVE
5.1 Discussion
5.2 Recommendation
5.3 Conclusion
5.4 Reference.
CHAPTER ONE 1.1 INTRODUCTIONIn Niger we are blessed with abundant mineral resources, which include crude oil, palm oil clay and coal etc. some of the resources are refined and exported while some are exported in crude form for foreign exchange. Nigeria being one of the developing countries, the over-dependence on the importation of these refined and high has result in an economic degradation and high standard of living.
Some of these mineral resource, because they are crude in the natural sence, thy must be refined before it is fit for human consumption and other industrial application. For instance, palm oil processed from palm fruit has to be refined to remove impurities and the yellowish red colour to made it more suitable for human consumption and other industrial processes. This project research is focusing on the rate of adsorption of these palm oil with synthetic adsorbent (coal)
Coal is a black combustible solid rich in carbon and some variety of hydrocarbon. It is found in a stratified sedimentary deposit sometime at great depths. All coal owe their origin to slow decomposition and chemical conversion of immense masses of organic mineral. Coal can be classified according to rank, than is according to the degree of metamorphosing in the series which are mostly base on the carbon content of the coal substance. The ranks of coal are peat, lignite, bituminous and anthracite coal.
Coal has being tested to be an adsorbent, thus, this research work is to determine the rate of adsorption of palm oil with these adsorbent. Palm oil belong to the family of lipids which are compounds that are soluble in organic solvent like ester, acetone, alcohol, chloroform but insoluble in water. Crude palm oil be refine through the method of degumming, dandification, deodorization, bleaching, neutralization etc.
1.2 SCOPE/OBJECTIVE OF THE PROJECT
The objective of this project research is to determine the rate of adsorption of palm oil with synthetic adsorbent (coal). The refining of palm oil using synthetic adsorbent at various time internal and temperature will be used to detect the extent the purity and colour change in natural palm oil. This involves the following steps. I the activation coal and 2, adsorption process proper.
This material content is developed to serve as a GUIDE for students to conduct academic research
Delivery: Within 24 hours
Advertise Here
Not what you were looking for? Perform a search
What's your project topic?
Comment on Facebook:
Related Project Materials
- 1.
PREPARATION OF SOAP USING DIFFERENT TYPES OF OILS AND EXPLORING ITS PROPERTIES
ABSTRACT Soaps are the sodium salts or potassium salts of stearic acids or any other fatty acids. They are prepared by the saponification proces...More »
Item Type: Project Material | 50 pages | 0 engagements |
- 2.
THE REFURBISHMENT OF TEMPERATURE CONTROL APPARATUS
ABSTRACT A temperature control apparatus an “Armfield model was refurbished. The methodology employed were to detect the pulty parts of the ...More »
Item Type: Project Material | 50 pages | 8,503 engagements |
- 3.
PRODUCTION OF CRUDE OIL-DRILLING PROCESS
ABSTRACT The tremendous (large) demand of some petroleum fractions in our modern world today has drive some professionals...More »
Item Type: Project Material | 50 pages | 0 engagements |
- 4.
PRODUCTION OF LIQUID AND VAPORIZED PERFUME
ABSTRACT This research project was carried out principally for the production of liquid and vapourized perfumes from local raw materials. The ...More »
Item Type: Project Material | 50 pages | 14,390 engagements |
- 5.
PROCESS AND QUALITY FACTORS IN LAUNDRY AND TOILET SOAP PRODUCTION
ABSTRACT This projects is aimed at knowing the process and quality factor in Laundary and Toilet Soap Projection. Various factors affected the...More »
Item Type: Project Material | 50 pages | 9,007 engagements |
- 6.
THE USE OF LOCAL PIGMENTS AND EXTENDERS FOR FORMULATION & PRODUCTION OF EMULSION PAINT
ABSTRACT The major aim of this project research work is to produce emulsion paint from locally sourced pigment & extenders. The materials use...More »
Item Type: Project Material | 50 pages | 9,009 engagements |